se7ensport
|
| posted on 8/1/12 at 01:40 PM |
|
|
Stainless steel exhaust "S" bend
I'm in need of an "S" bend in stainless steel to mount my silencer, the pipe needs to be 63mm ID, dimension "X" is 30mm
and dimension "Y" is 180mm
 
exhaust bend
Thanks
Alex
[Edited on 8/1/12 by se7ensport]
|
|
|
|
|
designer
|
| posted on 8/1/12 at 03:14 PM |
|
|
Why not use a flexible if it is not visible outside the car?
|
|
|
se7ensport
|
| posted on 8/1/12 at 03:47 PM |
|
|
I'd initially planned to use flexible pipe, but it will be visable from the outside and load bearing as I don't want to mount the silencer
front and rear.
|
|
|
Chippy
|
| posted on 8/1/12 at 04:04 PM |
|
|
You could try contacting OJZ engineering, they do a vast range of parts, and may even do you a special. Check out their web site, but DO NOT send them
an email as you will never get an answer, phone instead. HTH Ray
To make a car go faster, just add lightness. Colin Chapman - OR - fit a bigger engine. Chippy
|
|
|
minitici
|
| posted on 8/1/12 at 04:16 PM |
|
|
Chop a 90 degree bend, rotate the two halves and re-weld.
|
|
|
se7ensport
|
| posted on 14/1/12 at 03:22 PM |
|
|
Wunoff sorted me out with this, not cheap at £60 (£35 for the work, £15 delivery and £10 vat), but it does the job nicely:
 
Link pipe
|
|
|
