Hi!,
I am after a Pinto engine / gearbox spacer fit to my Zetec... Anyone ?

thanks
Dave Bailey

didnt know one was needed.
but i maybe wrong, as ive got an MT75 box on mine

If you can't get one make it . Use the bell housing as a pattern

Whay do you mean by spacer? Just the thin plate to keep crap out is normally needed as the type 9 fits a zetec perfectly....

This picture showa the only part that doesn't line up. I just cut round it to make the starter fit OK.
Rescued attachment Starter point.JPG

I have dry sumped the zetec I have and so the flywheel is exposed at the bottom and so I should cover this up..

Dave B