small ally cylindrical piece with an off centre hole and some spanner flats at one end, needs to be accurate as its part of a tensioner assembly for my engine. I can take a picture later to give an idea and can send the one i have (borrowed off a mate) to be copied.

Anyone able to do this for me for reasonable remuneration?

cheers,

Andrew.

[Edited on 9/3/06 by ned]

Can do it for free if you send me the sketch. I have a shedload of ally bar in 25mm, 50mm and 75mm. Can insert a ball race if required.

You could upload the photie / drawing to your Photo Archive and I can get it from there.

Cheers,

Eddy

[Edited on 9/3/06 by eddymcclements]

well get a piccie and some measurements tonight.

many thanks..

Ned.

hopefully this makes sense. drawing/sketch is not to scale

THE 141MM MEASUREMENT IS ACTUALLY 41MM, I MISREAD IT OFF MY RULE!

[Edited on 14/3/06 by ned]
Rescued attachment IMG_1869b.jpg

and another
Rescued attachment IMG_1872b.jpg