I need some threaded tube to make up my top harness mounts. 4x 2" long with a thead for SA Belt harnesses (7/16ths UNF?). Any suggestions?

Ask Nik The Skid.

He did mine for me. Quick turnaround and good price.

Pat...

quote:

---

Originally posted by Avoneer
Ask Nik The Skid.

He did mine for me. Quick turnaround and good price.

Pat...

---

He sells on ebay and is on the list.
N.Skidmore@wlv.ac.uk

I just made mine from 20mm mild steel bar drilled it in the lathe with a 9.9mm bit and tapped it 7/16"UNF. I then cut 20mm holes into my roll bar cross tube and welded them in. Picture below shows the bar in place before welding.
Cheers
Jon
Rescued attachment DSCF0012.JPG

Job done!
Rescued attachment DSCF0016.JPG

Close up!
Rescued attachment DSCF0029.JPG