im guessing its not gonna be the same cos of the tails, if yours has tails you should be able to use any old 3 pin male and female and replace the one on the tps?
unless you just couldnt be arsed.
Description
[Edited on 13/10/05 by suparuss]
I need a plug to connect to the TPS on my R1 Carbs. Anyone happen to have a spare?
Regards,Ian.
Hi mate
If you find any let me know as i have been after one for a while
Cheers
me too
if they are the same as an r6 i might have one from when i did my conversion. had to buy 2 sets of bodies cos the engine is 5 cyls.
cant remember how much of the loom came with them though. ill check when im in the garage in the morning and let you know.
Russ.
oops, mine are throttle bodies. just noticed it is for carbs.
might still be the same though? if i have a spare ill take a piccy so you can decide for youself.
quote:
Originally posted by suparuss
oops, mine are throttle bodies. just noticed it is for carbs.
might still be the same though? if i have a spare ill take a piccy so you can decide for youself.
ere you go.
im guessing its not gonna be the same cos of the tails, if yours has tails you should be able to use any old 3 pin male and female and replace the one
on the tps?
unless you just couldnt be arsed.
Description
[Edited on 13/10/05 by suparuss]
Totally different! I'm looking for a male plug that plugs into the TPS itself. The female section is oval , and the part no is different as well.
Thanks for the offer Russ. If I can't find one, I shall have a go at Bodging/making one!
Regards,Ian.
Ian
I know its a way off (4 weeks) but there is a motorbike auto jumble near me at kempton park race course on the 12th november.
I will also be looking for a plug for the R1 carb TPS so i'll keep em peeled if you can wait.
Many thanks Bob, I appreciate that. I'll keep on looking, as it looks like there are at least four of us looking for one.
Regards, Ian.