Who does laser cut manifold blanks in steel? Looking for one to make bike carb manifold.
Denis.

FastDan on here makes them here's mine for a duratec engine



Throttle Bodies on Duratec

Email me bboyfastdan@hotmail.com if you are interested. I can get steel flanges done however they are one-off's (as I make in alu as you can see).

What carbs are you looking to fit?
I have this manifold available if it is any use to you. X-flow to Yamaha R6. £55 inc postage.



Nick

thanks for the replies fella's.
I have a set of zx9 carbs to fit.
I will talk to fast dan.

Regards denis

Dan.......E mail sent.

[Edited on 30/6/10 by kipper]