Just fitted megasquirt to my xflow but need a couple of bits. Can anyone help please:
4 x Blanking screws that fit in top of DHLA carbs when Manometer take offs are removed.
1 x Inlet manifold servo take off blanking plug.
1 x DHLA TPS mounting bracket, etc

I think I have a set of blanking screws, can you check what thread they are and I'll make sure they are correct for you....

I think they are
Thread length = 5mm

Thread diameter = 6.5mm
I got this off the Dellorto website for the take offs, which I have, just need something to plug them up when not in use

Found them, they are 5mm M5 thread, still have the fibre washers amazingly...
Rescued attachment Plugs.jpg

U2U sent