I need a 7" sierra diff and driveshafts for my car. It needs to be a 3.62 or 3.92 non-lsd diff with push-in shafts. The push in shafts must be the fatter of the two types, i.e. originally off any sierra APART FROM any 1.6 or any mk 1 1.8.

I'm not normally this fussy but I have a Tran-X LSD to fit and it needs to go into this specific diff casing with these driveshafts. I have a

I'm in Kent, so within collection distance is preferred, but will consider anything. What have you got? I'm happy to swap for the 7" 3.62 diff and shafts I have here in GWO (but with the skinnier driveshafts!) or can pay with real money!

Tom

I think I've got a set of the shafts your after, if your stuck

they were in the garage when I got it (from my dad, he thinks there off our old 2.0 sierra estate) so they've been there a while, but they should clean up (I hope) they'd need new boots though
which bit do I measure to check the size ?




[Edited on 1/12/09 by mcerd1]

It's the measurement of the section that pushes into the diff that matters. The following pic was from my original post where I was trying to work out why my driveshafts won't fit!


sierra driveshaft

[Edited on 1/12/09 by djtom]

Hi, I've got various diffs 7" 3.62 and 3.92, I'm just outside eastbourne, east sussex so fairly local. Not sure how to identify which casings they are, but they are stripped so I could take some measurements if u like.

I've got the complete rear (and front) end from a 2.0 E reg estate if that's any good - just outside Folkestone.

A complete rear end sounds great - U2U me with how much you want for it.

Cheers
Tom