Anyone got an oil catch tank with two inlets they want to sell? Dont care if its a bit battered and in need of re-painting

What have you got?

[Edited on 14/5/09 by tegwin]

Stainless biscuit tin Morrison’s £2.99, bore a big hole in the lid for the feed in, grommet and push the pipe through then a hose coupling or similar for the outlet and put a cheap filter on top from Ebay, of if really tight drill a selection of small holes in a really neat patten.

I modified an ally drinks bottle. Drilled the lid and bonded 2 tubes in.

Aldi have them in at the moment. About £5.

adrian

or a posh stainless loo brush holder from bhs £12

Got an ally one you can have 16cm high x 12cm wide x 14cm deep It's got 2 13mm connectors at top one end, 2 10mm connectors on other end and a 15mm drain near the bottom on one side. Well manky but should clean up.

Forgot to say, just want postage for it.

[Edited on 15-5-09 by 40inches]

I used a oil spray gun can remove the gun bit and fit a small filter on
the top is removable to clean the old crap oil
I also drilled the side and fitted a air line end though the side to fit a pipe to it
its a aluminium one so nice and shiny

-------!!------

[Edited on 17/5/09 by jacko]

Nice new catch tank

[Edited on 17/5/09 by jacko]