MakeEverything
|
| posted on 16/7/10 at 10:23 AM |
|
|
FS: Cosworth V6 Engine
I need to sell the cosworth V6 to focus my attention on the project in hand. I really wanted to fit it at a later date but i dont have the space to
keep it much longer.
Engine is a 90,000 mile engine which i am told had no rattles when i bought it. I still have the inlet manifold, exhaust manifolds, some wiring, ECU,
EDIS6 and coil pack (x2).
I have two sets of R6 throttle bodies which i was going to put on the engine, and am selling these too for £100 a set though one set has been stripped
down.
I am after £300 for the engine.
 
V6 engine
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
Is this a TRADE ADVERTISEMENT?? Click HERE to report it!
|
|
|
|
|
MakeEverything
|
| posted on 19/7/10 at 11:00 PM |
|
|
Its still here if anyone is interested.....
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
MakeEverything
|
| posted on 23/7/10 at 10:18 PM |
|
|
You know you want to buy this....
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
mangogrooveworkshop
|
| posted on 24/7/10 at 12:13 AM |
|
|
It would go nicely in the p100 
|
|
|
MakeEverything
|
| posted on 24/7/10 at 07:33 AM |
|
|
quote:
Originally posted by mangogrooveworkshop
It would go nicely in the p100
Buy it then!!!
Thats the second time youve said that!
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
scootz
|
| posted on 24/7/10 at 08:45 AM |
|
|
Can the BOB-variant claim to be a 'cosworth' engine?
Is it not a bit like referring to non-coscast headed red-tops as Cosworth engines?
It's Evolution Baby!
|
|
|
MakeEverything
|
| posted on 24/7/10 at 10:36 AM |
|
|
quote:
Originally posted by scootz
Can the BOB-variant claim to be a 'cosworth' engine?
Is it not a bit like referring to non-coscast headed red-tops as Cosworth engines?
It is a cosworth engine. It has a cosworth crank, rods, pistons, head and valvetrain, and cams.
So, no, but then i didnt name it.
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
|
scootz
|
| posted on 24/7/10 at 10:46 AM |
|
|
My mistake...
I knew that the original BOA was made in Wellinborough by Cosworth, but I'd always thought that the BOB variant was made exclusively by Ford
using components machined by them in-house, but based on the original Cosworth design.
Me bad!
It's Evolution Baby!
|
|
|
