Purchased new in May 2010. No longer required due to the purchase of a lovely new screw compressor. Currently this is not wired up but can be if you want to see/hear it working. Looking for offers over £400. I had it serviced in Feb 2012. Use in my small workshop to run my blaster and powder coating unit.
One owner from new, low mileage and a FSH
Here's some tech stuff. Compressor currently stored at SN12 near Melksham.
Abac 5.5 HP 415 volt V Belt Drive Air Compressor Mounted on a 200 Litre Receiver ideal for garage workshops.

Model Number B5924/200

Abac lubricated compressors come with cast iron cylinders for long life and the slow running pump unit gives low noise and long durability. Slow running belt drive for smooth efficient operation.

Features:-
•5.5 HP Motor
•415 volt three phase supply
•200 Litre Air Receiver –
•Piston Displacement: 24 cfm
•Free Air Delivered (FAD): 17.7cfm
•Pressure: 10bar 145psi
•Low speed pump
•Cast Iron Cylinder
•Control: auto stop/start
•Weight: 133 kg
•Overall size mm: 1400X495X1010 mm:

Description

Description
[img]http://[/img]

[Edited on 8/7/12 by fullpint]

Pic's added. Can email more if req'd.. Just u2u your email.. Cheers; Steve

Open to a deal on a swap!! WHY? 13" wheels for my Indy, a nice SLR camera, a new wife Super-mono,

Will be going on fleabay at the weekend and hopefully will go for £500+... You just never can tell

Now on EBay for those who fancy a bid or two....
ABAC 415V Compressor 200lt tank 3 phase 5.5HP | eBay

I have a nice set of minilite 13" wheels with cr500 tyres, hardly used and came off a caterham, if you wanna do a deal?

Could be.. Will send you a u2u for pic's, my email is tpcs2010@live.com

SOLD SOLD... Went for a mere £360 and gone to a trader.. Someone missed out on a good deal here. Never mind.