Hi all,

Another unfinished project for sale.

Everything bar mirrors, screen and other little bits (electrical conecors p-clips and so on IVA covers) are there to finish. It just needs a little time which I don't have at the moment.

Pictures can be seen in my profile (I hope)

The car is based in Derby and I would like £3500 I would also be willing to swap it for something finished (Kit car, 205, mx5, Capri, mini anything intresting) and cash either way.

Spec:
-The kit a velocity xt powder coated black chassis with blue GRP
-1992 k sierra donor with logbook
-Twin 40 Dellortos and manifold
-2.0 Zetec silver top with pre 95 letter from ford. The timing belt and water pump replaced (For one which spins the correct way) and shorter escort sump fitted
-Full stainless exhaust (Made by shiny bits in sheffield)
-Weber alpha 3d engine management
-Polo rad and pacet cooling fan
-Facet fuel pump and filter king presure regulator
-Wiring loom (Vicki green)
-Chrome headlamps and lenses
-Round rear lamps (NAS style)
-Gaz 2&1/4 coil overs
-Quick rack & solid rack mounts (Rally design tec-rac)
-Greengauges clocks (Speed, Tacho, fuel, oil pressure, coolant temp, oil temp and volts)
-Savage switches and warning lights (See seperate picture of the dash)
-Cobra roadster seats and runners in tan colour with blue trim
-Willians harneses (not fitted) see picures
-Carpet materials (Not fitted)
-17" alloys and tyres
-Alloy fuel tank (Fuel lines need are in place but need P-clipping)
-Sierra discs brakes and calipers all round
-keyless immobiliser (not fitted) and battery master switch
-all brake lines and flexi's fitted
-westfield alternator mounting kit
-New cluch
-Silicon hoses, ali t-pieces/pipes
-Ali catch tank and expansion tank

The car starts, runs drives stops. The bulk of the work left is wiring up the lights and some body work needs fitting (Nose cone, front wings and bonnet) I'm sure it could be on the road before the end of summer if someone is handy with the wiring. The seats also need fitting. Then preparation for IVA, and I intended to have the suspension and carbs set up properly.

Either reply, U2U, send a e-mail to bigdrew1@hotmail.co.uk or call me on 07922104748 and I can send you lots of pictures + more info

More pictures added
Description

Description

Bump..

Any intrest?..

At all?

sent U2u

Replied, Yes I am still intrested and was waiting on them pictures!

Bump for the weekend..

Bump. Is the price of this too high?..

Open to offers..

Still for sale.

Will put in on Ebay this week

Then maybe consider splitting it..

You may be better off if you can get it finished even if you have to pay to get it done and IVAd Your likely to get a much better price for not an awful lot of hassle?? Best of luck whichever way you go.

As much as I would like to do the above, I don't think paying to have it finished is going to be financially viable, and I don't have the time to do it myself.

Seriously considering breaking it now. I will start a thread with individual prices once I have had a think about it.

Drop me a U2U if there is any interest in any bits!


[Edited on 12/9/11 by bigdrew]

U2U sent, is this still for sale ? ? ? ?