I need to sell the cosworth V6 to focus my attention on the project in hand. I really wanted to fit it at a later date but i dont have the space to
keep it much longer.
Engine is a 90,000 mile engine which i am told had no rattles when i bought it. I still have the inlet manifold, exhaust manifolds, some wiring, ECU,
EDIS6 and coil pack (x2).
I have two sets of R6 throttle bodies which i was going to put on the engine, and am selling these too for £100 a set though one set has been stripped
down.
I am after £300 for the engine.
V6 engine
Its still here if anyone is interested.....
You know you want to buy this....
It would go nicely in the p100 
quote:
Originally posted by mangogrooveworkshop
It would go nicely in the p100
Can the BOB-variant claim to be a 'cosworth' engine?
Is it not a bit like referring to non-coscast headed red-tops as Cosworth engines?
quote:
Originally posted by scootz
Can the BOB-variant claim to be a 'cosworth' engine?
Is it not a bit like referring to non-coscast headed red-tops as Cosworth engines?
My mistake...
I knew that the original BOA was made in Wellinborough by Cosworth, but I'd always thought that the BOB variant was made exclusively by Ford
using components machined by them in-house, but based on the original Cosworth design.
Me bad!