bikkel
|
| posted on 23/1/05 at 11:50 AM |
|
|
seat fixing
hi all
i've a MK indy , but i don't know how to mount/fix the MK GRp seats.
I want them as far back as possible.
any tips, ?
thanks koen
www.zx12r-indy.tk
www.zx12r-indy.tk
|
|
|
|
|
Peteff
|
| posted on 23/1/05 at 12:32 PM |
|
|
I made a couple of brackets for mine out of plate. 3mm aluminium would do it. You could profile them or drill them to lighten them if you want. A
basic sketch not to scale or anything just to give an idea. I used button head stainless bolts to fasten through the seat with a washer to spread the
load.
[Edited on 23/1/05 by Peteff]
 
Rescued attachment bracket.jpg
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
BMF
|
| posted on 23/1/05 at 04:23 PM |
|
|
I used stainless box section with threads tapped into one side which you screw bolts into from below the floor, and for the seats drilled a 8mm hole
all the way through, and then opened up the top one to 12mm so a scoket head bolt can pass through and then into the base of the seat
|
|
|
Rorty
|
| posted on 24/1/05 at 04:30 AM |
|
|
Again, 3mm ally.
 
Rescued attachment ally_seat_mount.jpg
Cheers, Rorty.
"Faster than a speeding Pullet".
PLEASE DON'T U2U ME IF YOU WANT A QUICK RESPONSE. TRY EMAILING ME INSTEAD!
|
|
|
BMF
|
| posted on 24/1/05 at 09:59 AM |
|
|
How come you guys seem to be able to use side mounts? My MK seats came with the nuts moulded into the base.
|
|
|
timf
|
| posted on 24/1/05 at 11:03 AM |
|
|
make up a bracket to fit the seat base
eg
| |
|_________________|
|
|
|
