givemethebighammer
|
| posted on 30/10/03 at 09:05 PM |
|
|
dropped into Midland Wheels this afternoon. The black vinyl seats Mark shows (£150 pair) have a steel tubular frame and don't really compress at
all. Spent some time trying to work out if I could cut an inch or two out of the centre of the seat frame and reweld. Decided that this would make the
seat uncomfortable due to the area you bum fits into being too narrow and the bucket sides digging into your back. Time to make some seats myself I
thinks..
|
|
|
|
|
splitrivet
|
| posted on 31/10/03 at 10:03 AM |
|
|
Sorry bout delay again Andy been out the office for 2 days.Those seats are 19 1/2 inches accross the base including the rake adjuster wheel which is
removable the inner steel frame for the backs are about 18 inch acros, the squab and rears protrude about 1 inch either side of this but are quite
squashy.Also got some 14 inch Alloys off of a Pug 205 with the right offset in good nickwith decent low profile rubber for £80 if there of any use for
anyone.
Cheers,
Bob.
I used to be a Werewolf but I'm alright nowwoooooooooooooo
|
|
|
