I've just cocked up my transmission cover (the top part) again. It could be salvageable if----- I could get hold of some 90 degree trim ideally aluminium angle. I have looked in B&Q but there ally angle would fail the 2mm radius as it has a sharp external corner, does any one:-

1. know here I could get some ally angle with a 2mm radius,
2. Or know where I could get some ‘other’ 90 degree trim to do the same job.


Cheers in advance.

B

You want some "Hockey Stick" Trim, I think some other places call it "J" Trim aswell.

It's available form a few of the kit manufacturers, but not sure if the conventional shops sell it.

HTH
Steve

ETA - Photo, here's a shot of mine (powder coated black on the tran tunnel and plain ali on the outside)

rubber floor and new tran tunn

[Edited on 23/2/08 by worX]

You can get 90 degree rubber trim.... SVA very friendly...

I used b+q type trim but arrissed off the corner with a grinder and finished it with wet and dry paper it passed sva no problem

worX

Thats the stuff i want, give me, give me, give me......

where can i get some, please someone heeeeeeelp!!!!!!

Mine is from MAC#1, but it can also be bought from MK, Aries Motorsport and a few other manufacturers...
Steve

quote:

---

Originally posted by The Baron
worX

Thats the stuff i want, give me, give me, give me......

where can i get some, please someone heeeeeeelp!!!!!!

---

I used anodized step edging from B&Q which Mr SVA loved.

I took the hockey trim off mine and commisioned a full pad to be made. Much better solution - all together more tailored. Only cost £55 with some pockets.

Try Woolies Trim

Cheers

Ian