This is a photo of a steering wheel I would like to use post SVA.
It is quite an old wheel with imperial dimensions.
What I would like to know is if any of the modern wheel Bosses will either fit or are of suitable size to be modified.
The sizes of the wheel are:
Centre hole = 4 1/2"
Bolt PCD = 5"
6 bolt holes.



Steering wheel

Classic Mountney boss should fit that.

Mine passed SVA with one of those fitted, just cover the centre up so you can't feel the studs.

Yup deffo Mountney wheel. Astrali bosses also fit (if you can find one) and are collapsible and SVA friendly.
Agree with Pete, cover fixings up with centre pad. (I used cut up manta centre)

Marcus

Looks exactly the same as my new mountney wheel so would imagine a new mountney boss will be fine, however ill measure mine up tomorrow for you to make sure their the same.

Mountney were helpful with a question I had about a boss recenly

http://www.mountneyltd.com/contact.htm

you need the mountney classic boss, not the mountney 'm' range boss.

the m range boss is the little one to fit momo/sparco etc etc wheels.

hth
tom