Transmission Tunnel edges with to get through IVA? i.e. 2.5mm radius?

Thanks in anticipation.

Regards.......Neil

I used tadpole beading and hidem banding. Wasn't particularly attractive but it was quite cheap/easy and guaranteed to pass.

Links BEADING & HIDEM

Beading was andwiched under the top panel of the tunnel and the hidem was used to cover all the screw heads.

Regards
Davie

I used luminium extrusion provided by my manufacturer.

It's known as "hockey stick trim" or J-profile trim...

I shaped mine round the tran tnnel and dash and also had it powder coated black...



rubber floor and new tran tunn



rubber floor and new tran tunn

quote:

---

Originally posted by Steve Hignett
I used luminium extrusion provided by my manufacturer.

It's known as "hockey stick trim" or J-profile trim...

I shaped mine round the tran tnnel and dash and also had it powder coated black...


The hockey stick comes from these people
http://www.eahorsebox.co.uk/pages/racing-range.lasso

---

Ben_Copeland - 22/1/10 at 06:51 AM

quote:

---

Originally posted by Nash
Transmission Tunnel edges with to get through IVA? i.e. 2.5mm radius?

Thanks in anticipation.

Regards.......Neil

---

Ooooo progress????

---

Bluemoon - 22/1/10 at 11:18 AM

I used hard PVC type P trim sandwiched as daviep (actually used evostick to the top panel to hold it in place to make removal/fitting simple). Did't like the picture frame J section look they look to wide to me IMHO..

Dan

---

Bumble - 22/1/10 at 02:19 PM

quote:

---

Originally posted by mangogrooveworkshop

quote:

---

Originally posted by Steve Hignett
I used luminium extrusion provided by my manufacturer.

It's known as "hockey stick trim" or J-profile trim...

I shaped mine round the tran tnnel and dash and also had it powder coated black...


The hockey stick comes from these people
http://www.eahorsebox.co.uk/pages/racing-range.lasso

---

---

Bumble - 22/1/10 at 02:20 PM

I spoke to them recently and they no longer sell it.......is there anywhere else you can get it??

quote:

---

Originally posted by mangogrooveworkshop

quote:

---

Originally posted by Steve Hignett
I used luminium extrusion provided by my manufacturer.

It's known as "hockey stick trim" or J-profile trim...

I shaped mine round the tran tnnel and dash and also had it powder coated black...


The hockey stick comes from these people
http://www.eahorsebox.co.uk/pages/racing-range.lasso

---

---

---

stevebubs - 22/1/10 at 03:28 PM

http://www.woolies-trim.co.uk

---