rincewind23
|
| posted on 21/10/12 at 06:32 PM |
|
|
Steering advice
Hi all,
Looking for a bit of advice from peeps who have done similar before..
I'm building a McSorley 442 with a Rover v8 engine in it. This means I need to put a "kink" in the steering column. I think I need
to fit a straight piece to the steering rack, then a UJ, another straight piece, then another UJ to connect to the steering column.
I was hoping to get some thoughts on connections. I can't seem to find any straight female spline connectors for the steering rack connector,
and should I use spline connections for all the other parts? i.e. both ends of the middle section, and replace the triangle on the end of the steering
column with a male spline.
Cheers,
KEv.
|
|
|
|
|
austin man
|
| posted on 21/10/12 at 08:04 PM |
|
|
had to do the same for a Zetec
 
mk steering
Life is like a bowl of fruit, funny how all the weird looking ones are left alone
|
|
|
T66
|
| posted on 21/10/12 at 08:05 PM |
|
|
Not mine, but from my archive.
|
|
|
rincewind23
|
| posted on 21/10/12 at 10:54 PM |
|
|
Thanks for the photos, guys.
So am I correct in thinking that in both cases, there is a UJ directly on the steering rack, and another one further out?
|
|
|
.jpg)
