Jay k
|
| posted on 15/4/09 at 01:32 PM |
|
|
Clevis fixing
I am trying to locate a clevis jaw with a m8 thread and with a 6mm pin, for the brake pushrod / pedal fixing.
Can anyone tell me where I can buy one from?
Thanks in advance
Jay K
|
|
|
|
|
Keith Weiland
|
| posted on 15/4/09 at 01:59 PM |
|
|
Is this any good?
http://www.cbsonline.co.uk/master-cylinder-clevis-clevis-130-p.asp
|
|
|
Jay k
|
| posted on 15/4/09 at 02:17 PM |
|
|
Not quite - it has the wrong thread. I need m8
|
|
|
02GF74
|
| posted on 15/4/09 at 02:18 PM |
|
|
Rally Design sell the clevis pi with 8 mm thread. I used one for brake master screw on to end of M8 bolt with head cut off.
I cannot recall what the diameter of the hole was but I think it was 8 mm - you can alwasy sleeve the hole with tube - B&Q do steel tube 8 mm 10
mm etc, all about 1 mm wal thickness. If you get stuck, I can post you a short bit of 8 mm OD tube (pretty sure I should have some about)
|
|
|
Jay k
|
| posted on 15/4/09 at 02:21 PM |
|
|
The hole in the pedal is 6mm and I do not want to enlarge, so ideally need the m8 thread with 6mm pin
|
|
|
02GF74
|
| posted on 15/4/09 at 02:43 PM |
|
|
^^^ or sleeve the pin to match the 8 mm hole.
|
|
|
Jay k
|
| posted on 15/4/09 at 02:46 PM |
|
|
I haven't got an 8mm hole ??? It's 6mm
|
|
|
Cousin Cleotis
|
| posted on 15/4/09 at 05:46 PM |
|
|
Why cant you drill the hole to 8mm? 6mm sounds small for a brake clevis, most are 8mm.
Paul
[Edited on 15/4/09 by Cousin Cleotis]
|
|
|
Jay k
|
| posted on 16/4/09 at 07:40 AM |
|
|
Here is a pic of the brake pedal, as you will see the hole indicated is for the clevis. The bigger the hole the less metal there will beteewn the 2
holes.
 
pedals
[Edited on 16/4/09 by Jay k]
|
|
|
