blakep82
|
| posted on 14/4/09 at 02:43 PM |
|
|
misalignment spacer sources?
wheres best? i need about 50 for my car, and from rally design or mcgill motorsports, it starts to get pretty expensive!
i guess could use washers since i don't need the 'misalignment' allowance, but i'd rather use something solid as it makes it
easier to fit
any ideas?
1/2" ones they are
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
|
|
blakep82
|
| posted on 14/4/09 at 03:01 PM |
|
|
lol just loads of rose joints 
________________________
IVA manual link http://www.businesslink.gov.uk/bdotg/action/detail?type=RESOURCES&itemId=1081997083
don't write OT on a new thread title, you're creating the topic, everything you write is very much ON topic!
|
|
|
Fred W B
|
| posted on 14/4/09 at 04:40 PM |
|
|
I had spacers cut / turned from a stainless pipe with a suitable inner and od. They have a chamfer on the end that goes against the ball.
 
rod end detail
 
rod end exp
Cheers
Fred W B
[Edited on 14/4/09 by Fred W B]
You can do it quickly. You can do it cheap. You can do it right. – Pick any two.
|
|
|
40inches
|
| posted on 14/4/09 at 07:35 PM |
|
|
I get mine from here http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&ssPageName=STRK:MEWNX:IT&item=330319085302 mail him, might do a deal
for bulk?
|
|
|
