richyo
|
| posted on 28/1/04 at 10:51 AM |
|
|
Fuel tank Rubber Strips
The book sugests to use rubber strip to insulate the fuel tank from the chassis. is this what others have used ? If so where did they get it ? or are
there other alternatives. Would a closed cell polyethylene material do ?
Any thoughts or comments greatly appreciated. Thanks.
|
|
|
|
|
theconrodkid
|
| posted on 28/1/04 at 12:04 PM |
|
|
i used rubber matting
who cares who wins
pass the pork pies
|
|
|
jonti
|
| posted on 28/1/04 at 12:20 PM |
|
|
If you mean the stuff to go under the straps and between the mountings as per pikki then I can let you have some. Its 2" x .25" self
adhesive rubber tape.I only needed a couple of mtrs but had to buy a 25mtr roll.
 
Rescued attachment Fule-Tank.JPG
OFROK
|
|
|
richyo
|
| posted on 28/1/04 at 01:36 PM |
|
|
Thanks for the offer Jonti but by luck I've managed to "find " some at work.
|
|
|
RoadkillUK
|
| posted on 29/1/04 at 01:19 AM |
|
|
I was going to use an innertube from a pedalbike but I bought some 25mm closed cell foam adhesive strip from one of the shows and used that
instead.
I did look for a photo but it really doesn't show over the edges enough.
Roadkill - Lee
www.bradford7.co.uk
Latest Picture (14 Sept 2014)
|
|
|
