Morning all!

I sent a post a while ago about how I'd managed to get a cheap manifold from the states for my Honda Vtec engine.
It needed a little modification but I knew that before I purchased it. It cost me £108 shipped from door to door.
I've since bought a 60 degree bend to attach to the end. I cut the existing end connection off and removed the Lam sensor nut. A friend of mine has kindly tig welded the new end and Lam nut on.
Sorry about the quality of the pic, well pleased with the result! The rest of the system slides together and will be held together with springs.
Rescued attachment image_00005.jpg

that end pipe look like 3 inches! very smart though, is a huge bike can going on the end of it?

it's 2 1/2" stainless steel pipe, I have a 90 degree and 180 degree stainless 2 1/2" pipes that slide on. The can with have an integrated CAT in it. I'm having the can made.

Nice and shiney and what a bargain

£78 for the three bent pieces of 2 1/2" stainless pipe + connector for the can.

£280 for the cat can

pity it didn't come with a boot tidy...