Was looking at my column and paddle shift earlier and noticed it's a tad wobbly ( technical term there )

Should I have some sort of bearing btween the shaft and the paddle shift housing you reckon?

Cheers
Ben

yes remove the one from end of sierra colume
Rescued attachment gulf indy 010.jpg

you need the bearing out of the sierra colume, just needs pressing in

Cheers lads, i'll try and hunt one down.

if you get real stuck http://cgi.ebay.co.uk/FORD-SIERRA-STEERING-COLUMN-BUSH-KIT-SRK10_W0QQcmdZViewItemQQitemZ360007605756

Cheers chaps, just ordered some £6 delivered is better than rooting through the scrappy lol

That's the bush kit o go through the bulkhead.

There's a small bearing in the top of the sierra column in the aluminium colar that has the ignition barrel attached. It's very thin and cheap looking, but it does the trick.

I don't have a photo, but someone might come along in a minute who does.