Hi,
I fittered my uprights, brake plates on last weekend without sanding the uprights down, as shown in this photo? do you really need to do this? mine seem to fit okay?

(photo taken from avon-kitcar.co.uk)

thanks
Rescued attachment pic19.jpg

I don`t remember having to do that on mine!!

obviously it will depend on the brake setup wich is choosen on the rear.

maybe its for wilwoods nececary but not for standard sierra.

Tks

Have you tried fitting the back plate?

I think it was the opposite corners that needed grinding off.

Why would you need to sand them down?

Pat...

Think it depends upon what donor the rear brakes came off. I can't remember whether my drums were the larger or smaller sierra ones, but I didn't have to grind anything off. If yours appear to fit with no fouling, go for it.....

I made a upright and had to grind them.
It's is that the back-plate for drum-brakes don't fit.

Grtz

Did you get the plates to fit after all the woes in your previous post?

Pat...