Anyone know which brake pipe ends these are in the RD book?

Part number would be good. I need to convert some female ends to male bulkhead ends on my flexis.

Cheers,
David
Rescued attachment Male bulkhead fitting 2.JPG

If you got the flexi set from GTS why do you need to change them?
I thought I would have to as well but after chatting to RD I screwed the female ends into the calipers (that are meant to take a male) with a copper washer under the hex to seal against the caliper face.
Does this make sense?

I think that is a Euroquip male bulkhead convex seat, RD1503 fitting (if it's M10).

I think that is a Euroquip male bulkhead convex seat, RD1503 fitting (if it's M10)

I'm sure you are absolutely right. The copper pipe with a double flare fits to the convex end.

John

Yes this fitting is RD1503.

Rally Design Ltd

Cheers gents, ordered the bits the other night, hopefully they will be here today.