After much faffing I decided to bite the bullet and make this part myself. After much carefull setting up of the top slide with DTI, I machined this beauty. I was really worried about the matching taper but it turned out perfect. Initial fit showed good contact with machinist blue. When I bolted it up proper I actually struggled to seperate the parts which I'm taking as a good sign.

Its essentially converting my MGZR front upright to take a balljoint, like the sierra mushroom adapters but bigger.

I am a little pleased with myself.


Adapter

[Edited on 28/4/14 by liam.mccaffrey]

I made this,... not sure if it works, but it was great fun,.


hose_sensor

hose with water temperature sensor housing



[Edited on 28/4/14 by HowardB]

quote:

---

Originally posted by HowardB
I made this,... not sure if it works, but it was great fun,.


hose_sensor

hose with water temperature sensor housing



[Edited on 28/4/14 by HowardB]

---

na,.... it was a tube, and a collar heat shrink fitted,. -20 and +250C,.. then finished,..



Solid would have been more swarf than I have space for,.