I wanted to get this finished at uni but exams inconsiderately got in the way

Would anybody be able to do a quick milling job for some beer tokens?

I need to put two flats (15mm or slightly under wide), 180 degrees apart on the larger diameter section, then a 4mm tapped hole on each (I can tap the hole if its drilled to 3mm).
Ideally I would like another pass on a lathe to make a nice shiny finish, but that isn't crucial.

The material is fairly soft ali:


Column collar to be milled

If anyone could manage to do this for me, it would be very much appreciated - and beer tokens would be sent

I can do that. You will have to post it down to me etc.

Tilly

Fantastic, thank you! You have u2u