Hi,

Looking for some inspiration regards front wishbone construction

Pics of what you have made and any tips would be ideal!

Thanks

Here you go


Rescued attachment Intercooler_rad_low_view_small.JPG

Shock points at the ball joint so no bending motion on the lower bone, a common fault due to bad design.

Regards Mark

Gasp! you mean as in the Locost and myriad copies of ...Designs?? :-)

My top top would be to read the very very long thread on here about front wishbones bending - reduce bending loads anywhere and if possible avoid them all together

Next - make a decent jig


Second Jig

Weld carefully - distortion is a PITA.

You can buy ready made tubes for bushes and ready made bungs for both oval and round tubing if you are using rod ends - a lot quicker than making your own.

These are sweet if you fancy a bit of hammer work.

Paul G


Description