I have a set of Wolfrace Slotmags which I will be fitting shortly, but need a set of nuts, the taper 'appears' to be 90°, but is more likely to be 60° - does anyone know for sure


Nut Insert

Don't you need two part (nut + chamfered washer) Wolfrace type nuts like these?

Wolfrace FIT Sleeved wheel Nuts -14mmx1.5 thread (VW) on eBay (end time 19-Apr-11 16:38:14 BST)

Obv in the correct thread.

JC

[Edited on 28/3/11 by SeaBass]

quote:

---

Originally posted by SeaBass
Don't you need two part (nut + chamfered washer) Wolfrace type nuts like these?

Wolfrace FIT Sleeved wheel Nuts -14mmx1.5 thread (VW) on eBay (end time 19-Apr-11 16:38:14 BST)

Obv in the correct thread.

JC

[Edited on 28/3/11 by SeaBass]

---

Looking at the picture they look very much like standard ford tapers which I think are 60 deg's. I would get hold of one and just try it for fit. HTH Ray

looks like a Peugeot type fitment which has a slight taper and flat washer (205 gti) but they use bolts not nuts

quote:

---

Originally posted by Chippy
Looking at the picture they look very much like standard ford tapers which I think are 60 deg's. I would get hold of one and just try it for fit. HTH Ray

---

To me they look like they originally took sleeve nuts and have been 'adapted' for taper nuts. What diameter is the hole?