Hi,
It seems to me that it is going to be almost impossible to get my steering wheel parallel to the dash etc and at the same time avoid all the gubbins around the pedal box (maintaining less than a 15 degree angle with UJs etc). I have fitted a servo which makes even less space. Are you going to suggest I remove the bugger after all that f***ing about?

How 'straight' is straight enough!?

Also: Is it a case of either the crushable column or the two UJs with the offset shaft or is there a case for both for good measure?
Rescued attachment MVC-003F.JPG

I'm using an escort peddle box, like you. Used a sierra servo and master cyliner, which you can mount near the bottom of the pedals because its assisted. This makes plenty of space, if you take the column through the peddle box.

Peddle Box Mods


[Edited on 11/6/04 by Ben_Copeland]

and here for the servo Picture

why are you using a servo? are you making a tank?