Having read GaryM's excellent post on installing FZR600 carbs on a Xflow I got a set from a well known auction site(?) to install on a 1600 Pinto. The post said, as others have, to drill the main jet to 1.5mm. Which is the main jet? Anyone know of documentation to a: identify exactly which carbs I have and b: which adjustment/jet does what? I also assume the carbs should be at a slight angle to make the top of the float chamber horizontal? without knowing and seeing the bike they were on I can't tell. Any other words of advice on these carbs.

[Edited on 6/8/09 by Dickyboy]
Rescued attachment mikuni1.jpg

Hiya

They don't look like my FZR600 carbs?

If you u2u me an email address I can email you the carbs section of the FZR600 workshop manual.

Cheers
Gary