kev R1
|
| posted on 31/7/06 at 08:09 PM |
|
|
grille radius? sva
do you reckon this will be ok re: radius at the sva test as it is recessed, i've seen quite a few of you have flush grilles?
 
Rescued attachment sva grille.JPG
|
|
|
|
|
keith
|
| posted on 31/7/06 at 08:22 PM |
|
|
grill
as long as its not sharp to the touch,if you run your hand all over exposed bits to make sure its not sharp thats what sva man does(passed re-test
today).
 
Rescued attachment th_9ad1c54d.jpg
|
|
|
nitram38
|
| posted on 31/7/06 at 09:05 PM |
|
|
I was told by the sva man that the mesh needs to be between 25mm and 40mm and the radius of the material should be no smaller than 1mm dia.
|
|
|
JohnN
|
| posted on 31/7/06 at 10:03 PM |
|
|
I have a stainless mesh in the front, 5mm spacing 1mm woven wire, examiner wasn't bothered, said that for air intakes it was ok
|
|
|
Chippy
|
| posted on 31/7/06 at 10:08 PM |
|
|
Agree with John, mine is about the same size, SVA man never even looked at it. Ray
|
|
|
02GF74
|
| posted on 1/8/06 at 12:52 PM |
|
|
from the replies ^^^^ seems this is another one of the grey areas;
|
|
|
Miguel
|
| posted on 1/8/06 at 06:02 PM |
|
|
Trust me as an SVA examiner its fine.
|
|
|
