chriscook
|
| posted on 18/4/06 at 01:09 PM |
|
|
Bonnet vents
Will these bonnet vents need any mesh behind them for SVA or are they ok as they stand? Opinions please....
Cheers,
Chris
[Edited on 18/4/06 by chriscook]
 
Rescued attachment img_1063.jpg
|
|
|
|
|
Hellfire
|
| posted on 18/4/06 at 02:44 PM |
|
|
I don't think the standard 4"/5" sphere will contact those Chris also they are rear facing so in theory should be alright.
[Edited on 18-4-06 by Hellfire]
|
|
|
chriscook
|
| posted on 18/4/06 at 06:27 PM |
|
|
Lets hope so its too late to change it now.....
|
|
|
Simon
|
| posted on 18/4/06 at 10:11 PM |
|
|
Chris,
You could radius the hole lips if you're that concerned, but I'd go along with Hellfire re sphere not contacting.
ATB
Simon
|
|
|
David Jenkins
|
| posted on 19/4/06 at 07:42 AM |
|
|
'No sharp edges' is a good general rule to consider - if they can't be reached with the sphere then just round the edges off.
David
|
|
|
chriscook
|
| posted on 19/4/06 at 03:36 PM |
|
|
After the photo was taken i blunted the edges and they passed  He did check they were less than 40mm though.
|
|
|
