NS Dev
|
| posted on 8/3/06 at 11:48 AM |
|
|
Running loom inside car
Daft question so not really sure why I am asking but I assume SVA will be fine with my rear loom run inside the passenger space of the car?
I am using trailer cable and want to run it in the corner between the floor and the tunnel side on the passenenger side of the tunnel.
That way it can't get damaged easily, can pick up the handbrake switch wire from the handbrake mounted on the passenger side of the tunnel, and
will exit into the "boot area" in a nice place.
see any probs with that?
Was wondering but then thought that 90% of everyday cars run the loom under the carpet inside the car!
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|
|
|
|
wicket
|
| posted on 8/3/06 at 12:45 PM |
|
|
Done just that, covered the loom with plastic channel, see pic
 
Rescued attachment Cockpit2.jpg
|
|
|
NS Dev
|
| posted on 8/3/06 at 03:51 PM |
|
|
super smashin great, I'm not the only one then!
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|
|
