stuiesav
|
| posted on 18/8/08 at 09:47 PM |
|
|
seatbelt fixings
Hi there... Wonder if anyone can offer some assistance.. so nearing completion of my viento - and just fixing seatbelt harness in place. Can see the
obvious place where the belt goes on the roll bars, however - no obvious fixings in the cars... Anyone got any suggestions / pictures that I can
follow???
Thanks in advance,
Stuart.
|
|
|
|
|
kenton
|
| posted on 18/8/08 at 09:56 PM |
|
|
Hi there,
v easy to find... bracket with a hole welded to bottom chassis rail at rear of seat area. If you have put the tunnel sides on the bracket will be
behind the tunnel side.
|
|
|
simonk
|
| posted on 18/8/08 at 10:04 PM |
|
|
That's on the tunnel side - from memory on mine the hole was drilled in the reinforcing web on the outerside but not drilled through the thin
steel plate that forms the inner rear wheelarch - I had to drill that through. 2 x 12mm suspension washers should take up each gap between the alloy
tunnel side panel and the drilled triangular web in the chassis by the diff nose. Hope that helps.
Simon
|
|
|
stuiesav
|
| posted on 18/8/08 at 10:07 PM |
|
|
so this is an old chassis - had it for around 4 years - i am told this was a "missing hole" that was not pre-drilled for me... 8-)
|
|
|
Paul (Notts)
|
| posted on 19/8/08 at 06:40 AM |
|
|
The following 3 pics show the bracket drilled on the wheel side , The fitting from the inside and the bracket on the transmission tunnel side ( note
the large square washer between the ally and the bracket to space the fitting out)
If you are still unsure I can probably find other pics.
 
Rescued attachment 1.jpg
|
|
|
Paul (Notts)
|
| posted on 19/8/08 at 06:41 AM |
|
|
2
 
Rescued attachment 2.jpg
|
|
|
Paul (Notts)
|
| posted on 19/8/08 at 06:41 AM |
|
|
3
 
Rescued attachment 3.jpg
|
|
|
stuiesav
|
| posted on 19/8/08 at 06:58 AM |
|
|
Paul - you are a star - thanks so much - massively helpful!
|
|
|
