Board logo

New bits arrived today
jollygreengiant - 30/7/08 at 08:11 PM

Well I received the new bits I had been waiting for today.

Anyone want to guess where they fit.

My new bits
My new bits

Those who might already know should not post.

Oh and thanks Dave they will be perfect.


Edit bit - if you want to copy the design ask but if some one starts mass producing them then I hold all rights of general design & manufature.

[Edited on 30/7/08 by jollygreengiant]

BenB - 30/7/08 at 08:15 PM

quote:
Originally posted by jollygreengiant

Anyone want to guess where they fit.


Do they need batteries??

thunderace - 30/7/08 at 08:26 PM

indicator and light stalks

nib1980 - 30/7/08 at 08:28 PM

throttle feed for the jet engine?

chris_smith - 30/7/08 at 08:33 PM

indicator extensions??

COREdevelopments - 30/7/08 at 08:34 PM

stunt pegs for your rally burner?

Mr G - 30/7/08 at 08:35 PM

bmx stunt pegs

r1_pete - 30/7/08 at 08:35 PM

Handles for the pillion on Chris' avatar.....

jollygreengiant - 30/7/08 at 08:37 PM

quote:
Originally posted by thunderace
indicator and light stalks


Ok so they go on these
Go on these
Go on these

Like this
Like this
Like this

and will go into my indicator extension bar ( doubles as a bumper bar) to be clamped in by some grub screws from behind
into indicator bar
into indicator bar

Dangle_kt - 30/7/08 at 08:44 PM

will that mean you don't need to have mr SVA dreaded globe rattling round the front suspension?

eznfrank - 30/7/08 at 08:54 PM

quote:
Originally posted by r1_pete
Handles for the pillion on Chris' avatar.....


or Handles for the pillion on CoreDevelopments avatar!!!

jollygreengiant - 30/7/08 at 10:18 PM

quote:
Originally posted by Dangle_kt
will that mean you don't need to have mr SVA dreaded globe rattling round the front suspension?

Hopefully that is the general idea. But you know the testers usually have other ideas.

02GF74 - 31/7/08 at 08:12 AM

hope you are using one tube for the bar or have fairly hefty mounts - the legnth means they will wobble quite a bit.

jollygreengiant - 31/7/08 at 09:29 AM

quote:
Originally posted by 02GF74
hope you are using one tube for the bar or have fairly hefty mounts - the legnth means they will wobble quite a bit.


Yep approx 1inch steel tube in one piece across the top of the nose. It will be bolted either side of centre (bolts to also hold grille in) through rubber grommets in nose cone sides and just inside of nose the bar will have electrical condiut exit routes each side that will assist the bar in deforming 'should' anything make hard enough contact so that damage to the nose would be minimalised.

rusty nuts - 31/7/08 at 08:07 PM

I thought they might have been larger jets for the "pink barbie"