Board logo

Velocity Progress
Dave Bailey - 21/3/08 at 06:30 PM

I know....sad but I had to tell someone..the wife doen't want to know!

In fact she said why not go and live in the garage! Hmmm I thought trouble is no room for a bed!

I decided to tackle a job I had been putting off for months fitting the rear panel... Every noise as I was pushing it on I thought was going to end up in a crack but to my surprise it fitted a treat after some fetling!

So engine is in, brakes are on, diff, prop, scuttle, seat, wiring loom in but not connected, fuel lines, ....all done...the list goes on....Just need to wire up and get and exhaust then I might actually get it started. Great feeling the I can see a light at the end of the tunnel.

Dave B


donut - 21/3/08 at 06:41 PM

Just make sure the wife doesn't turn that light off!!!

Well done, every job done is that much closer to finishing.


omega0684 - 21/3/08 at 10:00 PM

its true,

it really is a great feeling when you get close to the starting step, but believe me when i say you are still a long way away! when you get all the big stuff done its the one million and one little things that you need to do to get that bad boy ready for sva, it takes a week to read the manual!!!!

all the best, the light can only get bigger!!!

p.s got any pics, its always nice to see others builds

[Edited on 21/3/08 by omega0684]


jollygreengiant - 21/3/08 at 10:51 PM

Trust me, you do not need an exhaust for first run.


Dave Bailey - 21/3/08 at 10:56 PM

I'll take some pictures tomorrow!


RichB - 22/3/08 at 11:49 PM

Even if you don't have room for a bed a hamock will do!


saigonij - 23/3/08 at 10:59 AM

where are these pictures then?


Dave Bailey - 23/3/08 at 12:54 PM

today! honest!
Would I lie to you already!

I'll upload em during the footy!

Dave B


Dave Bailey - 23/3/08 at 02:08 PM

Some pictures!


rear right
rear right


rear right2
rear right2


Engine Bay 3
Engine Bay 3


Steering Wheel
Steering Wheel


Gear Lever Position
Gear Lever Position


Engine Bay 1
Engine Bay 1


Scuttle
Scuttle


Engine Bay 2
Engine Bay 2


Front Right
Front Right


Dave Bailey - 23/3/08 at 02:13 PM

A few more:-


Diff_drive shafts
Diff_drive shafts

Wiring Panel location
Wiring Panel location

Engine Front Through Nose
Engine Front Through Nose

Engine Front Through Nose 2
Engine Front Through Nose 2


omega0684 - 23/3/08 at 08:18 PM

OMG!!!

there must be at LEAST a few hundred quids worth of goodridge fixings and hosing in there! This man is building in style!

What engine is that in there, mondeo st?

Alex


Dave Bailey - 23/3/08 at 08:24 PM

The fuel lines are new but from the US...and the oil lines are from a nascar again from the US.....The lot cost £140.00
which I thought was quite good!

The motor is from a 500 mile written off focus ST170 with throttle bodies from a 2.0 micra rally car.

Dave B