Evening all.

Can somebody please post a photo as to how they have run the throttle cable on an EFI Rover V8 - I assume the single and dual plenums have the throttle cable running to the same point.

Many thanks...

can anyone help? need some ideas please....

Dan

It goes from the Throttle Pedal to the Carb or bit on the Plenum if injected. How and where you run it is up to you.
I would try to stop it drooping onto the exhaust pipes. It tends to melt the plastic.


Engine Right1

Thanks Geoff - looks like you've been busy polishing under there!

I'm retrofitting an EFI RV8 in place of a carb'd one and the cable runs in a different direction. I know where it's running from and to, just was looking for ideas as to how those with EFI lumps have routed the cable etc. Cheers