DaveFJ
|
| posted on 20/1/04 at 01:57 PM |
|
|
sierra pedal box re-assembly
Doh !
just finished making my new pedals and went to reassemble the sierra pedal box - now I can't remember the correct assembly.... Haynes is no help
either...
I 'think' the following is correct.....
 
sierra pedal box
Can anyone confirm this ?
cheers
Dave
Dave
"In Support of Help the Heroes" - Always
|
|
|
|
|
theconrodkid
|
| posted on 20/1/04 at 04:12 PM |
|
|
looks right,only ever seen them upside down and in the dark,if you get it wrong it wont fit or will be all floppy
who cares who wins
pass the pork pies
|
|
|
Mix
|
| posted on 21/1/04 at 08:51 AM |
|
|
Close but no cigar
Just done a physical on my pedal box, (currently in 'as removed' state).
Assembly is as per your diagram except the large washer and the smallest plastic bush are transposed.
Cheers Mick
|
|
|
DaveFJ
|
| posted on 21/1/04 at 09:24 AM |
|
|
cheers
sounds more logical now you say it....
the clip would dig in to the plastic bush in my arrangement...
also the 'proper' way round i'll get more space between my pedals....
Thanx
Dave
Dave
"In Support of Help the Heroes" - Always
|
|
|
Mark Allanson
|
| posted on 23/1/04 at 07:28 PM |
|
|
Does this help, I cut the clutch bush in half and put one half either side of the pedal to make it closer to the brake padal
 
Rescued attachment Pedal Bushes.jpg
If you can keep you head, whilst all others around you are losing theirs, you are not fully aware of the situation
|
|
|
