zekill
|
| posted on 9/9/12 at 05:46 PM |
|
|
sprocket issue
Hi all,
I have a problem with my sprocket adaptor, the bolt that retain it unscrew for about ten minutes trackday.
I have screw it with blue loctite but it's the same.
I have made a good 7075 washer, the same too.
What can I do ?
 
sprocket
Fisher Fury with Phoenix bodywork, Blade 919cc
|
|
|
|
|
Moorron
|
| posted on 9/9/12 at 06:49 PM |
|
|
Mine reused the original Bike bolt and washer. The washer is one you fold over the bolt after tightening it up, been fine from day one.
Maybe source the bolt and washer from your engine and then see what happens, it seems to me that your nice 7075 washer is the issue.
 
washer and bolt
[Edited on 9/9/12 by Moorron]
Sorry about my spelling, im an engineer and only work in numbers.
|
|
|
zekill
|
| posted on 9/9/12 at 06:56 PM |
|
|
thank for reply.
It seem to be a standard washer on my engine, 919 fireblade.
part 24
Fisher Fury with Phoenix bodywork, Blade 919cc
|
|
|
ashg
|
| posted on 9/9/12 at 10:23 PM |
|
|
use green high strength locktite 270 be warned though. once that stuff sets you will have little chance of ever getting the bolt out again.
the blue stuff is just basic thread locker for low stress environments. what did you use 222 or 243? 222 is super poo and only any good for tiny
little fixings. also before you use it clean out the threads on the bolt and output shaft with brake cleaner to remove any oily deposits
Anything With Tits or Wheels Will cost you MONEY!!
Haynes Roadster (Finished)
Exocet (Finished & Sold)
New Project (Started)
|
|
|
maccmike
|
| posted on 9/9/12 at 10:45 PM |
|
|
make sure its a correct factory torque too
|
|
|
zekill
|
| posted on 10/9/12 at 01:12 PM |
|
|
I use 243.
I have 602 in stock, I must try it.
Fisher Fury with Phoenix bodywork, Blade 919cc
|
|
|
Minicooper
|
| posted on 10/9/12 at 02:57 PM |
|
|
The Honda Blackbird uses the same spline as the R1 which has the splined washer available, if the fireblade spline is the same then you could use the
early 98~02 R1 splined washer on your fireblade
Cheers
David
|
|
|
zekill
|
| posted on 12/9/12 at 04:17 PM |
|
|
thanks all for reply.
I have use a bolt a bit longer scewed with loctite 603 (green).
I try this setup friday, I hope that work
Fisher Fury with Phoenix bodywork, Blade 919cc
|
|
|
zekill
|
| posted on 14/9/12 at 03:10 PM |
|
|
that work fine, thank all for help.
Fisher Fury with Phoenix bodywork, Blade 919cc
|
|
|
zekill
|
| posted on 15/9/12 at 06:14 AM |
|
|
I have a doubt:
the sprocket must have a lateral play or no ?
with my setup the sprocket is tighten without play, i'm not sure is correct.
Fisher Fury with Phoenix bodywork, Blade 919cc
|
|
|
