I bought some for my locost and they were 35mm long, 20mm o/d and 10mm i/d (metal tube)
Got them from www.mevspares.co.uk
Hope this helps
hi everybody,i need to replace the rubber bushes on the 4 bar rear axle set up.Can anyone tell me the spec of the origional bushes and what vehicle they came from?Alternativly has anyone fitted bushes from powerflex,polyflex,etc. many thanks kehale ps anyone know a good place/track for test and tune in surrey sussex area
I believe they are triumph, but you would have to measure them to be sure.
I bought some for my locost and they were 35mm long, 20mm o/d and 10mm i/d (metal tube)
Got them from www.mevspares.co.uk
Hope this helps
I used Freelander rear radius arm to hub bushes from www.polybush.co.uk ref PS01XP04 Orange 75 shore part no was 1-24-16
Seem to work OK but you should check dims etc. on their website before ordering.
HTH.
Cheers, Pewe10 
Hi mine are cortina Mk3/4 rear upper inner got them off rally design
quote:
Originally posted by benchmark51
I believe they are triumph, but you would have to measure them to be sure.
I bought some for my locost and they were 35mm long, 20mm o/d and 10mm i/d (metal tube)
Got them from www.mevspares.co.uk
Hope this helps
quote:thanks for your reply,i will investigate
Originally posted by kehale
quote:
Originally posted by benchmark51
I believe they are triumph, but you would have to measure them to be sure.
I bought some for my locost and they were 35mm long, 20mm o/d and 10mm i/d (metal tube)
Got them from www.mevspares.co.uk
Hope this helps