Afternoon all,

I'm in the process of getting hold of some alloys for my Striker which has Ford Sierra hubs. I think that the PCD is 4x108, and the C/Bore is 63.4 (can anyone confirm this?), but was wondering what offset to go for. I can get hold of some OZs with an offset of 37 - will these fit the Sierra hubs OK? Is there anything else I need to be wary of?

Also, I have some Peugeot 205 1.6GTi alloys which have the same PCD, but will I need a "plug" to change the Bore from 65.1 to 63.4, and will the offset be OK with these wheels?

Hope some one can help before I go and buy wheels that won't fit...

Thanks,

MRH

Just been sorting this out for my ST loco. The offset for a ford sierra is 38 but i`m using sierra hubs and these foul against the chassis and it turns out i need a 16 offset. Don`t make a costly mistake without checking first will the manufacturers is it raw now after they brought out sylvia.