Hi I have atached a pic of my R1 bike carbs with Bogg Brothers manifold and set up on my zetec.....

Question Has anybody got pics of an R1 air box still atached if you can..I need help with the pipes...There is 2 pipes that I beleive need to be fed by the airbox so that it will open the slides..?? Bogg Bro's said just to leave them to the atmosphere or cap them with a couple of vent filters.But im not convinced...
Help please I need to know where all the pipes run?? I have a fair idea but im not 100% ??Scan of haynes/workshop manual would be greatfully appreciated...

pic 2

Iv got pipes on mine that dont conect up

It still works fine

Wasa. thats a nice colour cam top uv got. If you dont mind me asking how much was the manifold. Im after doing similar with my zetec.. That looks a tidy set up.

I did the cam cover my self..Shot blasted it then sprayed it up ..looks good...cost a tenner
The manifold is £155+vat

The quality is ok but the mounting holes where a bit rough and they needed some work to fit(2 of them) but on the whole im pleased ... Air filter is the dear bit !!!!!

[Edited on 30/3/05 by big_wasa]

I thought was the 'Locost' builders website......

Here's mine..........
Rescued attachment Finished Manifiold 3 vvsml.jpg

Yes m8 should have had a go my self but having sold my bike I splashed the cash on some nice bits

I do try and do my own work honest Look at cam cover.......

[Edited on 30/3/05 by big_wasa]

You can look forward to those bike carbs , I put mine on last week and although they are not set correctly yet , they are still bloody good.

Opens up the top end frighteningly , it will all end in tears or a rev limiter!!

Hey, nice engine

I've also wondered about the various vent pipes which stick out of the R1 carbs.....

Thanks mate. That manifold does look neat.

Vent pipes open to atmosphere...........
Rescued attachment Carbs On Car 6 vvsml.jpg