Slow progress but hope to get some steel to malke a mount for the reverse box in the morning, else we'ere never going to get to Stoneleigh

Now the centre bearing is gone and replaced by the reverse to keep everthing even, I plan to put the reverse box on a slight angle so that there is roughly the same angle on the engine to reverse and then reverse to the diff.
Bad picture below trying to illustrate what I mean

Any problems with this?


PROPANLES

[Edited on 20/4/12 by ReMan]

Bailey Morris stated to me that as long as you are no more than 7degrees out of true, you will be ok. Remember, that is vertically, and horizontally too!

alway good to run the joint on an angle so that all of the joint is being moved and worked