Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Fuel pump location
Ian D

posted on 3/4/06 at 09:19 PM Reply With Quote
Fuel pump location

I have mounted my fuel pump for my fuel injected ZETEC under the top rail behind the seat. The aim being to keep it as high and away from water as possible. Is this going to cause a problem as I have read somewhere that the pump needs to be below the bottom of the tank as it needs to be gravity fed?


Thanks

View User's Profile E-Mail User View All Posts By User U2U Member
mark chandler

posted on 3/4/06 at 09:35 PM Reply With Quote
Not a good place I,m afraid, it needs to be level or even below the bottom of the tank, these are vane pumps so do not easily self prime and the fuel cools the motor.

Making it the highest point of the fuel line is asking for trouble as fuel will leech back to the tank when turned off and the pump will overheat/burn out in a few minutes while struggling to pull fuel uphill when you start.

Regards Mark

View User's Profile View All Posts By User U2U Member
Andrew Bause

posted on 3/4/06 at 10:44 PM Reply With Quote
Hi Ian,

My Bosch pump is mounted where yours is, as per attached picture. My AVON has covered over 8500 mile since SVA last May with no problems so far...

Cheers!

Andy Bause Rescued attachment tiger22 017.jpg
Rescued attachment tiger22 017.jpg






We have been doing so much with so little for so long - Now we can do anything with nothing!

View User's Profile View All Posts By User U2U Member
k33ts

posted on 3/4/06 at 10:46 PM Reply With Quote
mines there aswell with no problems.
View User's Profile View All Posts By User U2U Member
Danozeman

posted on 4/4/06 at 05:27 AM Reply With Quote
IIRC it depends what pump you have. If its a bike pump i think it should be lower or level with the bottom of the tank as they are primarily gravity fed.


quote:

as fuel will leech back to the tank when turned off and the pump will overheat/burn out in a few minutes while struggling to pull fuel uphill when you start.



A one way valve would soon stop the fuel draining back to the tank.





Dan

Built the purple peril!! Let the modifications begin!!

http://www.eastangliankitcars.co.uk

View User's Profile View All Posts By User U2U Member
Ian D

posted on 7/4/06 at 06:54 PM Reply With Quote
Guys,

Thanks for the commets. The pump I have is a SYTEC Feul injection pump FP603.

It does say its a rotary pump. but in the instructions there is no mention of needing to be gravity fed.

Ian

View User's Profile E-Mail User View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.