Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Fitting fuel sender
wombat

posted on 21/1/14 at 08:17 PM Reply With Quote
Fitting fuel sender

What is the best way of fixing the fuel sender into my brand new tank without getting swarf inside?
View User's Profile View All Posts By User U2U Member
Barkalarr
Contributor






Posts 942
Registered 14/3/12
Location Essex
Member Is Offline

Photo Archive Go!
Building: Caterham R300, Caterham Roadsport,Indy R1,Indy Zet

posted on 21/1/14 at 10:18 PM Reply With Quote
Drill it upside down.
You'll still need to give it a swoosh round with petrol, but that's what I've just done with mine.

View User's Profile View All Posts By User U2U Member
wombat

posted on 22/1/14 at 07:29 AM Reply With Quote
Is it then a self tapper fixing?
View User's Profile View All Posts By User U2U Member
Barkalarr
Contributor






Posts 942
Registered 14/3/12
Location Essex
Member Is Offline

Photo Archive Go!
Building: Caterham R300, Caterham Roadsport,Indy R1,Indy Zet

posted on 22/1/14 at 07:30 AM Reply With Quote
Yes.
View User's Profile View All Posts By User U2U Member
neilp1

posted on 22/1/14 at 03:58 PM Reply With Quote
I used masking tape sticky side up inside and then drilled & tapped hole making sure I took my time.
View User's Profile View All Posts By User U2U Member
wombat

posted on 22/1/14 at 04:02 PM Reply With Quote
Thx, upside down it is, was just talking to mate at work who suggested the masking tape too !
View User's Profile View All Posts By User U2U Member
Barkalarr
Contributor






Posts 942
Registered 14/3/12
Location Essex
Member Is Offline

Photo Archive Go!
Building: Caterham R300, Caterham Roadsport,Indy R1,Indy Zet

posted on 22/1/14 at 04:18 PM Reply With Quote
I guess you're going to mount your sender close to the filler cap so you can get in there with the sticky tape??

Like an idiot, i managed to cut out my sender right where the mounting brackets are so I had to make some new ones which straddle the sender - so make sure the sender missed the mounting brackets.

I used self tappers in my sender ..

Description
Description

Description
Description


[Edited on 22/1/14 by Barkalarr]

View User's Profile View All Posts By User U2U Member
wombat

posted on 22/1/14 at 04:32 PM Reply With Quote
The Avon tank comes with the sender hole pre drilled, so not a problem.
It will be a case of taping a couple and drilling then the other ones, fiddly but ok.
What did you use for the anti spill / roll over/ one way valve?
Did IVA ask for any paperwork for this?
You can buy one way valves from 4.99 to 40.99 from what I can tell....

View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.