anyone got a pic of their rear panelling near the diff for the tiger avon?
i currently have this arrangement but someone mentioned I need a lot more back there, not sure what though...
got some pics to help explain what I mean..
I was told the cables are not in the correct position but I dont know enough about this stuff to really know how to correct it.
any advice?
thanks as always
[Edited on 2/2/08 by jimbona2]
Rescued attachment DSCN0865.jpg
another pic
Rescued attachment DSCN0868.jpg
I can't see much wrong except no bolt in the tee and no bracket on the chassis where the flexi's and copper meet.
was told today by a mate that the cable going to the left wheel is in the wrong position? (should be where the arrow is in the pic below)
[Edited on 2/2/08 by jimbona2]
Rescued attachment DSCN0865.jpg
Won't make any difference.
adrian
This makes no difference, because the pressure stays the same in the lines, no matter how it's connected to the T-block.
This is how I did mine and it passed. Hope this helps.
Rescued attachment 2006-05-20 car piccys 002.JPG
Try again
Rescued attachment 2006-05-20 car piccys 002.JPG
It won't make any difference!
Brakes work on pressure not by flowing large amounts of fluid.
Leave it as it is.....
Looks like the Torx-bolt on the diff is not tightened!
About the brake-lines:
If you can get the air out I don't see a problem.
Maybe he mented the handbrake-cables?
BTW: what are those yellow-fellows?
[Edited on 2/2/08 by t.j.]
quote:
Originally posted by nitram38
I can't see much wrong except no bolt in the tee and no bracket on the chassis where the flexi's and copper meet.
just bought the brake compensator/ regulator from tiger
they also mentioned it must fit along the prop shaft (i.e. length ways) to pass sva...
has anyone got a photo of it fittered handy?
cheers
[Edited on 4/2/08 by jimbona2]
Try this I fitted it next to the Master cylinder. Its easy to get to as well
Ian
Try again
Brake regulator again
Rescued attachment Brake Regulator Compressed.JPG
did you make the joint that fits to the chassis?
[Edited on 5/2/08 by jimbona2]