Whats the crack with the rear diff mount? It is not mentioned in the book... I am assuming that only the two long bolts are required to holt it in place... If so can i grind off the rear thread holes

i used the 2 long bolts and also welded on some brackets to support the front end just inside the transmission tunnel
didn't use the rear mount
Rescued attachment S2400047.JPG

I made a rear diff steady for mine.

antonyg, aren't the nuts for the seat belts welded on the wrong side?

are there not 3 mounts?

I used the end mount as well.

I thik someone on here cut the end mount off, to find it was hollow and they had a big hole in the back plate (ned?)

whats wrong with leaving it as it is anyway?

atb

steve

yep they WERE until someone else pointed that out
that photos about 6 months old
Thanks Anyway for pointing it out

I'll leave it as is... Not sure as to whether I'll use the rear mount as a steady though

If you are hard mounting the diff then by using the rear mount you can use the diff case to add rigidity to the chassis.

Mick

I certainly would put a rear mount on . Mine has become loose before

Really?

i only used the two long bolts and didn't bother with the rear mounting point. no problems so far.(famous last words!)
scott