phoenix70
|
| posted on 3/9/06 at 05:12 PM |
|
|
MK Exhaust
Hi All,
I've got a couple of problems with my MK exhaust:
1 .. The rivets holding the end of the can on have all come loose, can anyone tell me the size these rivets should be (where I can get them would be
even better)
2 .. The exhaust silencer is sitting too low I think, it sit about an inch or more below the chassis, mainly due to the angle I've got my engine
at.
 
Exhaust 1
 
Exhaust2
So my question is, is it sitting too low and how can I adjust it?
[Edited on 3/9/06 by phoenix70]
|
|
|
|
|
MkIndy7
|
| posted on 3/9/06 at 05:24 PM |
|
|
We adjusted ours by cutting a V out of the weld where it becomes horizontal, bent it up and then had it re-welded
|
|
|
mangogrooveworkshop
|
| posted on 3/9/06 at 05:41 PM |
|
|
Better come over to the mgw to have a looky
Ps the rivits are here and you can use the bling air one to set them
|
|
|
